Tow ball mass calculator: check the load on your tow ball
Check your caravan's tow ball mass against the car's tow ball rating, and see how moving a load inside the van changes it.
Tow ball mass is the load your caravan presses down through its coupling onto the car. It changes every time you pack the van differently. It has to sit in a range: too little and the combination is more prone to sway, too much and it overloads the back of the car.
What the check does
The Load Lab works out your tow ball mass from the van's tare and where your load sits in it. Load ahead of the van's axles adds to the ball; load behind them takes it away. It compares the result with your car's tow ball rating, and carries the same load through to the car's GVM and rear axle. Move a box and watch it change. The rating starts from your car's published figure or your own. If neither is known, we use 10% of the towing capacity and label it derived, and you can type over it.
What you need
- Your tow vehicle: pick it and we fill in its published tow ball rating and towing capacity
- The caravan's plate figures: tare, ATM and GTM
- What you pack in the van, and where: front, over the axles or behind them
- Water tanks, and how full you travel
Common questions
Is 10% the rule?
No. It is a starting guide, not a legal limit. The limits are the ratings of the car, the towbar and the coupling, and the lowest one applies.
Why does my tow ball mass matter for the car?
It counts toward GVM, and because the ball sits behind the rear axle it loads that axle by more than its own weight. See front and rear axle limits.
Can I check the result with a jockey wheel scale?
Only roughly. The jockey wheel sits at a different point on the drawbar, so it usually reads higher than the load at the coupling. Our result is an estimate; a tow ball scale or a weighbridge measures it. See how to weigh your rig, and our full guide to tow ball mass.